Al2O3/Y-TZP and Y-TZP materials fabricated by stacking layers obtained by aqueous tape casting

Alumina–zirconia layered ceramics fabricated by stacking water processed green ceramic tapes

Assessment of natural and synthetic wollastonite as source for bioceramics preparation

artículo científico publicado en 2007

Bone neoformation of a novel porous resorbable Si-Ca-P-based ceramic with osteoconductive properties: physical and mechanical characterization, histological and histomorphometric study

artículo científico publicado en 2016

CaZrO 3 –MgO structural ceramics obtained by reaction sintering of dolomite-zirconia mixtures

Controlled Fracture Test for Brittle Ceramics

Crack mouth opening displacement controlled fracture tests of brittle ceramics

Densification of lightweight aluminum borate ceramics by direct sintering of milled powders

Design and processing of a ceramic laminate with high toughness and strong interfaces

Determination of mechanical properties of Al2O3/Y-TZP ceramic composites: Influence of testing method and residual stresses

Diopside-tricalcium phosphate bioactive ceramics for osteogenic differentiation of human adipose stem cells

scientific article published on 28 June 2019

Dynamic corrosion of Al2O3–ZrO2–SiO2 and Cr2O3-containing refractories by molten frits. Part I: Macroscopic analysis

Dynamic corrosion of Al2O3–ZrO2–SiO2 and Cr2O3-containing refractories by molten frits. Part II: Microstructural study

Effect of Al2TiO5 Content and Sintering Temperature on the Microstructure and Residual Stress of Al2O3–Al2TiO5 Ceramic Composites

Effect of Mg and Si co-substitution on microstructure and strength of tricalcium phosphate ceramics

scientific article published on 25 October 2013

Effect of graphene on setting and mechanical behaviour of tricalcium phosphate bioactive cements

artículo científico publicado en 2018

Effect of mullite additions on the fracture mode of alumina

article

Elastic behaviour of zirconium titanate bulk material at room and high temperature

scholarly article by E. López-López et al published December 2012 in Journal of the European Ceramic Society

Elastic behaviour of zirconium titanate-zirconia bulk composite materials at room and high temperature

scholarly article by E. López-López et al published December 2013 in Journal of the European Ceramic Society

Extraction of Lanthanum Oxide from Different Spent Fluid Catalytic Cracking Catalysts by Nitric Acid Leaching and Cyanex 923 Solvent Extraction Methods

Flaw Tolerant Ceramic Laminates with Negligible Residual Stresses between Layers

Forming of Ceramic Laminates Comprising Thin Layers of a Few Particles

Fractographic and acoustic emission of mullite-alumina-zirconia composites prepared by reaction sintering

Fractographic study of the alumina and zirconia particles embedded in mullite prepared by reaction sintering

Fracture Mechanisms in Laminates in the Alumina - Titania System

Fracture behaviour of microcrack-free alumina–aluminium titanate ceramics with second phase nanoparticles at alumina grain boundaries

Fracture of Monoliths Fabricated by Stacking Water Processed Green Ceramic Tapes

Fracture strength and fracture toughness of zirconium titanate–zirconia bulk composite materials

scholarly article by Emilio López-López et al published January 2015 in Journal of the European Ceramic Society

High-Temperature Mechanical Behavior of Stoichiometric Magnesium Spinel

High-temperature mechanical behaviour of flaw tolerant alumina–zirconia multilayered ceramics

Improved Green Strength of Ceramics Through Aqueous Gelcasting

Improved resistance of alumina to mild wear by aluminium titanate additions

article

Improved wear behaviour of alumina–aluminium titanate laminates with low residual stresses and large grained interfaces

In situ developed laminates with large microstructural differences between layers of similar composition

article

In vitro study of the proliferation and growth of human fetal osteoblasts on Mg and Si co-substituted tricalcium phosphate ceramics

artículo científico publicado en 2017

Indentation Damage and Residual Stress Field in Alumina-Y2O3-Stabilized Zirconia Composites

Influence of Titanium Dioxide on the Sintering and Microstructural Evolution of Mullite

scholarly article by Carmen Baudín & JOSE S. MOYA published 4 October 2006 in Journal of the American Ceramic Society

Influence of experimental variables on fracture toughness determined on SEVNB in three points bending. Mullite a case study

Influence of microstructural characteristics on fracture toughness of refractory materials

Influence of mullite additions on thermal shock resistance of dense alumina materials. Part 1: Processing studies

journal article; published in Advances in Applied Ceramics in 2001

Influence of mullite additions on thermal shock resistance of dense alumina materials. Part 2: Thermal properties and thermal shock behaviour

journal article; published in Advances in Applied Ceramics in 2001

Influence of phase composition on the sliding wear of composites in the system CaZrO3–MgO–ZrO2 against ZrO2 and steel

article

Influence of porosity on the mechanical behaviour of single phase β-TCP ceramics

Instrumented Vickers microindentation of alumina-based materials

Joining green ceramic tapes made from water-based slurries by applying low pressures at ambient temperature

Laminated Ceramic Structures within Alumina / YTZP System Obtained by Low Pressure Joining

Lanthanum Oxide Obtention from Different Spent Fluid Catalytic Cracking Catalysts

Layered materials with high strength and flaw tolerance based on alumina and aluminium titanate

Mechanical behaviour of directionally solidified alumina/aluminium titanate ceramics

Mechanical properties of mullite materials

Mechanical properties of zirconia ceramics biomimetically coated with calcium deficient hydroxyapatite

scientific article published on 27 July 2020

MgO–CaZrO3-based refractories for cement kilns

Microstructural design of ceramics for bone regeneration

Modelling of elastic modulus of CaZrO3-MgO composites using isotropic elastic and anisotropic models

Mullite materials from a 3:2 alumina-silica gel part I: Green processing and porosity

Multilayer coatings with improved reliability produced by aqueous electrophoretic deposition

Nanoindentation of Al2O3/Al2TiO5 composites: Small-scale mechanical properties of Al2TiO5 as reinforcement phase

Neutron diffraction investigation for possible anisotropy within monolithic Al2O3/Y-TZP composites fabricated by stacking together cast tapes

Neutron diffraction residual stress analysis of Al2O3/Y-TZP ceramic composites

Non-destructive characterisation of alumina/aluminium titanate composites using a micromechanical model and ultrasonic determinations

Non-destructive characterisation of alumina/aluminium titanate composites using a micromechanical model and ultrasonic determinations

article published in 2008

Nurse′s A-Phase: Synthesis and Characterization in the Binary System Ca2 SiO4 -Ca3 (PO4 )2

Oxidation of Mullite-Zirconia-Alumina-Silicon Carbide Composites

Phase evolution in reaction sintered zirconium titanate based materials

scholarly article by E. López-López et al published March 2010 in Journal of the European Ceramic Society

Piezo-spectroscopic characterization of alumina-aluminium titanate laminates

Piezo-spectroscopic characterization of alumina-zirconia layered composites

Processing and in vitro bioactivity of a β-Ca3(PO4)2–CaMg(SiO3)2 ceramic with the eutectic composition

article

Processing and sintering of a 3 : 2 alumina silica gel

Processing of Al2O3/Y-TZP laminates from water-based cast tapes

Processing of Alumina and Corresponding Composites

Processing of alumina-coated tetragonal zirconia materials and their response to sliding wear

Processing, nanoindentation and scratch testing of alumina-coated YTZP

Reaction sintered Al2O3/Al2TiO5 microcrack-free composites obtained by colloidal filtration

Reaction sintered zirconium titanate–zirconia bulk materials from 3Y2O3-stabilized zirconia and TiO2. Phase composition and their potential for thermal shock applications

article

Reaction sintering of colloidal processed mixtures of sub-micrometric alumina and nano-titania

Reduced strength degradation of alumina–aluminium titanate composite subjected to low-velocity impact loading

Relaciones microestructura-comportamiento mecánico en materiales de alúmina-hexaluminato cálcico

Residual Strain Profiles in Alumina-Zirconia Ceramic Composites

Residual strain scanning of alumina-based ceramic composites by neutron diffraction

Residual stress and diffraction line-broadening analysis of Al2O3/Y-TZP ceramic composites by neutron diffraction measurement

Sandwich materials formed by thick alumina tapes and thin-layered alumina–aluminium titanate structures shaped by EPD

Sliding wear of CaZrO 3 -MgO composites against ZrO 2 and steel

Stable Fracture Testing of Brittle Materials

Strength Analysis of Self-Supported Films Produced by Aqueous Electrophoretic Deposition

Strengthening at high temperatures by precipitates in Fe–Al–Nb alloys

Structural characterization of bulk ZrTiO4 and its potential for thermal shock applications

Synthesis of monoclinic Celsian from Coal Fly Ash by using a one-step solid-state reaction process

article by D. Long-González et al published March 2010 in Ceramics International

Tape casting of Y-TZP with low binder content

The high-temperature strength of some Fe3Al alloys

The main role of silica—Based cement free binders on the microstructural evolution and mechanical behaviour of high alumina castables

The potential of La-containing spent catalysts from fluid catalytic cracking as feedstock of mullite based refractories

Thermal expansion of zirconia–zirconium titanate materials obtained by slip casting of mixtures of Y-TZP–TiO2

scholarly article by Emilio López-López et al published December 2009 in Journal of the European Ceramic Society

Threshold strength evaluation on an Al2O3–ZrO2 multilayered system

Titanato de circonio: estabilidad termodinámica y expansión térmica

Work of fracture of a composite resin: fracture-toughening mechanisms

artículo científico publicado en 2009

Young’s modulus and hardness of multiphase CaZrO3-MgO ceramics by micro and nanoindentation